Magnum Sea and Land

Model: MAG3800™ MAG3800X™ marine.
Style: Arc cutting rod. 
Size: 3/8” x 18” (11.43 cm x 549 cm). 
Quantity: 50 per box. 
Weight: 14 lbs (6.4 kg).

Although our video shows the MAG3800™ easily cutting through 1.5" of plate, a smaller diameter rod was designed for cutting materials ranging from .500" and less. The MAG3800™ have been used for cutting old grain storage bins in farm settings or rusted hulls in marine conditions. The same rod is proficient in cutting sheet metal or I beams in commercial construction settings. Watch the video and see the MAG3800™ cut with amazing performance. Imagine the productivity. There are no preheating delays or material barriers. Easily melt through cast, stainless, manganese and more. Focused heat makes the difference. Ten-thousand degrees breaks all material barriers.

Model: MAG1200™ MAG1200X™ marine.
Style: Arc cutting rod. 
Size: 1/2” x 18” (15 cm x 549 cm). 
Quantity: 30 per box. 
Weight: 11 lbs (5 kg).

Our factory tests documented the MAG1200™ as a very powerful cutting tool when it comes to scrap, dismantling and salvage assignments. Our factory tests demonstrated the larger diameter .500" cutting rod was able to cut through a linear foot of 1.750" plate in twenty seconds, or twice as fast as the smaller .375 diameter arc rod below. We recommend the MAG1200™ for plate or related materials thicker than .500". Arc rods are ideal for cutting through thick cast iron which is impossible using oxyacetylene. They cut incredibly fast on A36 plate and stainless steel. Since a welder is employed, arc rods do not require an ignition source. Merely bringing the rod into contact with the grounded material causes the arc and subsequently the vaporization of the parent material.

Anyone familiar with air carbon arc cutting is also familiar with the loud, 140 decibel side effects. Unlike air arc gouging or carbon arc gouging, our oxy-arc cutting rods are quiet and spark spray is significantly less. A docimenter documented the sound at 57 decibels, or approximately the same as welding with a 7018 welding rod. Since the diameters are standard, they easily fit into most exothermic cutting torches using a standard collet. Magnum's MAG2001™ oxyarc cutting torch displays a cable for attaching the negative welding cable for convenient straight polarity cutting.